Features and Benefits of the ADCOLE Model 1300:
- Can handle up to 39" (1000 mm) length part (optional lengths are available)
- Capable of measuring as many as 24 features (lobes and journals)
- Measuring times between 50 to 65 seconds, depending on the size of the part
- Modular design for easy and maintenance
- Easy follower relocation for part variations
- 3600 data points per revolution per follower
- User-friendly software and programming menus
- Shop floor-hardened design
- Full length/wisth preceision granite surface plate
- Programmable reporting
- Automation communication and integration
Available Options:
- Programmable part elevator for accurate load/unload of parts into gage
- Clean and calibration bars are loaded/unloaded by the robot or gantry. Used to insert a cleaning bar for the follower tips than a calibration check of the gage
- Part identification
- LVDT nest for measuring spacing, flatness and runout of thrustfaces
- Chatter Analysis Software for monitoring grinders and machining
Crankshaft Measurement Parameters:
- Main and pin journal diameter, measured at three locations per journal (over oil holes were required). Accommodates journals of different diameters within the same part.
- Main and pin journal circularity (roundness) with LSC, MZC, (MRS), MIC and MCC circle evaluation methods according to ISO 6318
- Lobing evaluation over 360 degrees with selectable sliding window
- Main and pin journal cylindricity
- Main and pin journal straightness (linear profile) and barreling
- Main and pin journal taper
- Main and pin journal parallelism
- Main and pin journal center deviation
- Main journal thrustface radial and face runout
- Main journal concentricity/eccentricity and part bow correction to end journals
- Pin journal angular position (index error)
- Pin journal throw and true position
- Linear error plots or polar plots to CRT or printer with refence circle
- Calibration verification and temperature compensation